Complete Rear Axle Assemblies for Land Rover Defender 90 (1997-2016)

Restore the structural foundation and drivetrain integrity of your Land Rover Defender 90 with a Complete Rear Axle Assembly. When dealing with severe corrosion, bent tubes, or catastrophic internal component failure, swapping to a fully built replacement housing eliminates the labor and guesswork of piecing together individual differential units, half-shafts, and swivels.

Engineered as direct-fit replacements to factory specifications, these complete assemblies ensure correct rear geometry, proper alignment, and long-term durability for heavy-duty off-road or daily driving use.

Key Features

• Complete Drop-In Unit: Arrives fully assembled to drastically reduce workshop labor time and minimize the risk of sourcing or mixing incompatible internal components.
• Factory Alignment & Strength: Built to original equipment tolerances to maintain precise rear-end tracking, handling stability, and even tire wear.
• Heavy-Duty Construction: Manufactured from high-grade steel tubing designed to withstand heavy loads, towing strain, and harsh off-road impacts.

Available Options & Part Numbers

Select the correct assembly variant based on your vehicle's braking system configuration (applicable to Defender 90 models from chassis number VA128340 onwards):

• MA025394: Rear Axle Complete Assembly (With ABS) — Equivalent to OE reference TVK100450.
• Ma025395: Rear Axle Complete Assembly (Non-ABS) — Equivalent to OE reference TVK100440.

Vehicle Compatibility

• Land Rover Defender 90: Fits models from chassis number VA128340 onwards (covering late 300Tdi, Td5, and Puma eras up to 2016; verify your chassis number and braking setup prior to ordering).

Workshop Note: Due to the heavy weight and structural nature of a complete rear axle assembly, professional installation using a proper two-post lift and transmission jack is required. Always check differential fluid levels and bleed the brake system thoroughly if swapping an ABS-equipped unit.